Wii Sensor Bar Separate Pieces

# Details I couldn't print the original https://www.thingiverse.com/thing:5448890 because it's too long for by 200x200 mm printer, so I cut it down to this size. When electronics are installed, the back piece doesn't slide properly, so you will need to just push it on. Depending on how you print it, you can bend the walls to get it in. It holds nicely. You can adjust how far apart the pieces are if necessary for different sensitivity. ## Needed electronics 1. 6 IR LEDs (940 nm recommended) 2. 2 — Design: Diode_exe (Thingiverse #7400471), licença Creative Commons - Attribution - Share Alike. Impresso sob demanda em PLA na cor à sua escolha; dimensões aprox. 108×32×16 mm.

Também vendemos na Shopee e no Mercado Livre — procure por "TV-7400471".