CH Throttle Quadrant Detent Mod

This is an initial version of the detent mod for the CH throttle quadrant with 6 axes. I have been using this for a few months already with minimal maintenance and so far it's been pretty good! All prints were printed with SLS resin, can't tell you which because I used an online service. The idea behind this mod was to make a detent system that was replaceable and disengagable, and with as little destructive mods as possible. So far the minimum destructive modifications needed are 12 screw holes — Design: Jonnycool06 (Thingiverse #7392270), licença Creative Commons - Attribution - Share Alike. Impresso sob demanda em PLA na cor à sua escolha; dimensões aprox. 48×10×5 mm.

Dimensões	48 × 10 × 5 mm
Material	PLA — escolha a cor abaixo
Produção	Impresso sob demanda — 2 a 5 dias úteis
SKU	TV-7392270

Também vendemos na Shopee e no Mercado Livre — procure por "TV-7392270".